Hold-Fast Radiator Valves Ltd

Universal Thermostatic Replacement Head (Patent Pending)

Fits types l to a maximum 30mm thread diameter, and all types 2 & 3

Max. Size Thread: 30mm ►
	TYPES 1	TYPE 2	TYPE 3

TYPES 1: Use the Hold-Fast Adaptor with short grub screws (already fitted)
TYPE   2: Use the Hold-Fast Adaptor but change short grub screws for long grub screws
TYPE   3: Fit thermostatic head directly onto the valve (do not use other parts)         

	Piston Set 11mm Height	Grub  Screws   Top and Bottom
Measure From Top Edge of Adapter Adaptor Grub Screws				◄ Union Nut
	Adaptor	Piston	Sensor Setting (with union nut fully up)	Thermostatic Sensor Head (fitted to adaptor)

Fitting Instructions

                 Fit the Hold-Fast Adaptor to top of valve body. Make sure the Adaptor is sitting centre and flush to the valve body before tightening the grub screws with the Allen key. Insert piston into the Adaptor and adjust the two piston grub screws top and bottom equally. IMPORTANT: Set the piston to the height of 11mm above Adaptor top. (Use black template on card if required.) When height is set tighten lock nuts. Test valve by pushing piston down firmly with coin. If the valve is in good working order, the piston will return to the same height. To fit head, set sensor as shown in Sensor Setting. Make sure the grey union nut is rotated loosely up towards the sensor body until it is just showing below the lower part of the sensor head. Push the sensor head firmly onto the adaptor and rotate into position. While holding the sensor head firmly on the valve, secure connection by turning grey union nut clockwise by hand. Still holding the sensor head on the valve fully tighten grey union nut using parrot nose pliers. Set at desired room temperature. To remove sensor head turn union nut anti-clockwise to release locking mechanism.